My RNS |ZOOM 5554a DSL Setup

How to Configure those buggy Zoom 5554A DSL routers in router mode.

After logging in: admin/zoomadsl, click on Advanced Setup and then WAN Configuration.

(Note that the end result will allow computers connected to the router to get their IP address and DNS settings automatically. However, the primary DNS server will be 10.0.0.2, the router itself, which acts as a DNS Proxy Server.)

WAN Configuration

	I want to configure my modem:
	MANUALLY (because I have a static IP address and/or because I already know my Encapsulation, VPI, and VCI settings).
	AUTOMATICALLY (because I am NOT using a static IP address and I do NOT know my Encapsulation, VPI, and VCI settings).

Current Connection
Encapsulation:
VPI:
VCI:

Bridge:
IGMP:
IP Address:		Change to the IP address assigned to this DSL customer.
Subnet Mask:		Change to the netmask appropriate for this DSL customer.
Use DHCP:	Enable Disable	Set to Disable. After saving, it will display as Enable. If you need to update other settings, set it to Disable again before saving.
Default Route:
Gateway IP Address:			Change to the appropriate gateway for the customer's IP address.

DNS
Use DNS:	Enable Disable	Set to Enable to add DNS numbers After saving, it will always change to Disable.
Primary DNS Server:
Secondary DNS Server:

Virtual Circuit:

After you have saved your changes, you must write the new settings to flash to make them permanent. Click the button below to do this.

To Return to the Wan Configuration page after saving changes click on Advanced Status then Wan Configuration.